Factory reverse camera pinouts

Factory reverse camera pinouts

Postby fracturedranga on Sun Aug 12, 2018 2:48 pm

Hi guys,
Had a search with no joy so hoping someone can help,
I put a triple M tray on my new Triton, came with everything except a loom extension for the reverse camera,
Got around to extending it today and now all I get is a black screen with the guide lines.
What are the pinouts for the stock plug on the chassis rail
At the camera I had 5 leads a red, yellow, 2 blacks and a white.
The white is stripped back to bare in the short loom
The 2 blacks are crimped together in the loom.
Common sense would say white is a shield as its bare and contacts the foil wrap, black would be negative, no idea why there are 2, red and yellow would be 12v and signal,
What are the corrosponding pins on the chassis plug, im sure ive got it joined right so unless the little bit of heat from soldering has stuffed the camera I've got no idea what's going on?
fracturedranga
 
Posts: 6
Joined: Sat May 26, 2018 8:52 am


 

Re: Factory reverse camera pinouts

Postby fracturedranga on Sun Aug 12, 2018 3:44 pm

Worked it out all good, the loom plugs on the tub swap pin locations for the signal from where the camera plus in at the tailgate to where it plugs into the loom at the chassis
Pinouts for the loom plug as follows this is the tub loom side
Yellow - signal
Brown and yellow/redstripe - negative
White - 12v
White/red stripe- shield
Signal and -12v could be the other way round dint actually test but it works
fracturedranga
 
Posts: 6
Joined: Sat May 26, 2018 8:52 am

Re: Factory reverse camera pinouts

Postby snakesoup on Mon Aug 13, 2018 9:11 pm

Did you sell the hilux mate ?

Sent from my SM-G920I using Tapatalk
User avatar
snakesoup
 
Posts: 1115
Joined: Sun Feb 02, 2014 2:24 pm

Re: Factory reverse camera pinouts

Postby fracturedranga on Tue Aug 14, 2018 3:30 pm

It's still in the shed pulling the pump drive gears out this weekend and putting in a new fuel pump. If it breaks down again I'm going to torch it :D
fracturedranga
 
Posts: 6
Joined: Sat May 26, 2018 8:52 am


Return to Electrical

Who is online

Users browsing this forum: No registered users and 6 guests