MADMETHBANSHEE wrote:I have a hoist and pit
Might do up a DIY video when I install my step bar and bull bar for members to critique
Tim650 wrote:I'm in the process of fitting Ironman steps/rails and I'm not really keen on the fitting. In their PDF instructions online, it says "On some models you may need to check for clearance between spacer plate and the support rib on floor. If clearance is less than 10mm,
spacer plate will need to be modified and the
support rib in floor may need to be manipulated
for clearance as shown."
Now, cutting fittings on a brand new part seems like their R&D department went home early ..... also, when they say "floor rib in floor may need to be manipulated", what they mean is taking to your $40k vehicle with a grinder or hammer. .
Tim650 wrote:But this is a fitting issue that is very well known to the point that the fitting instructions state "modification" and "manipulation" of both the mounting brackets and vehicle underbody. Either way, I have had a go at fitting the side steps up to the point of not wanting to take to the vehicle with a hammer (as recommended by Ironman fitting instructions) and will be returning the steps and requesting a refund.
navh wrote:mine was the same with the bottom bolt plate. Also no bolts to re-attach the number plate, have to cut factory number plate light to connect to the new lights.
Users browsing this forum: No registered users and 2 guests