ag9111 wrote:Do you have a link to the internal bars on ebay?
Ray57MQ wrote:Looking good Matt, everytime I look at that holesaw I get the shivers....
Obviously the 4 holes have to lineup but, was it drilled from the top first using rhino template/measurements and the internal support unit brackets are adjustable for any possible boo boo's or other way round ?
Mattsglxr wrote:Other way round Ray. Get the internal bars in position then drill a 6mm pilot hole from underneath them move the internal bars and go to town with the 25mm hole saw from above. Once that is done line up the internal bars and bolt securely then a bit of silicon and fit up all the rhino bits.
Maxiy wrote:Hey Mate
How do you find the powertop ?
Users browsing this forum: No registered users and 2 guests