LED Spotties problem

Bull bars, sliders, wheel carriers etc!

LED Spotties problem

Postby raiderman on Thu Jan 13, 2022 7:03 pm

Hi All, fitted new Hard Korr 8.5 inch spotties to my MN and they were working when i pulled on High beam for a few weeks. Then when i pulled high beam off recently they would stay on???? I replaced relay and still no luck and wont come on now with high beam. I have had some 4 inch LEDS on their before these and never had a problem. Do i need to fit a resistor to make these work ??? are these pulling too many amps ?
I have checked all wiring and no problem as it all used to work until i added the new spotties
raiderman
 
Posts: 19
Joined: Mon Dec 08, 2014 4:03 pm


 

Re: LED Spotties problem

Postby NowForThe5th on Fri Jan 14, 2022 6:24 am

Did you use the harness supplied with the lights?

What kind of relay did you replace the original with?

Have you tried putting the original relay back in?

The problem you describe usually happens when the relay contacts fuse together either because of poor alignment or insufficient capacity of the relay. Have you tried a new relay? Try a name brand relay like Bosch or Hella.
Chris

If work is so terrific, why do they have to pay us to do it?
User avatar
NowForThe5th
Moderator
 
Posts: 9039
Joined: Sun Jun 15, 2008 2:00 pm
Location: Holt, ACT


Return to Exterior Mods

Who is online

Users browsing this forum: No registered users and 2 guests