Great idea.horseless2016 wrote:I built a rack to hold my rods/poles and rhino rack cage and bushman bag, cost about $60 to build.
I used 30mm angle to sit inside the top of the tub and welded 2 40mm SHS across the top.
To hold it down, i disassembled a door hinge, welded on two threads and used the pin end to grab the lip on the top of the tub. the threads protrude above the SHS where i clamp down a steel strip.
RHKTriton wrote:You could fix a roof rack rail or some unistrut along each side of the tub on the inner face of the top edge. Then make up brackets to fit crops bars, which could also be unistrut section. This would give you a fully adjustable frame.
Users browsing this forum: No registered users and 9 guests