dan.batto wrote:Very nice mate, coming up well! Where did you get the connectors for the tubing from? Also where did you get the tubing?
motoz wrote:dan.batto wrote:Very nice mate, coming up well! Where did you get the connectors for the tubing from? Also where did you get the tubing?
Capral Aluminium Qubelok is the product. It comes in 6.5m lengths its a lot cheaper if you can get it direct through one of their centers than through hardware stores. We use a fair bit of the stuff at work.
nickknock wrote:Damn i wish i knew that before lol. I was paying $15 for 2 m length
nickknock wrote:lol damn! I got ripped off! I rang the local steel suplier down south and they didnt sell aluminium.. which i found odd. So it was binnings for me. How thick is the walls off the tubing normally?
nickknock wrote:How thick is the walls off the tubing normally?
fraz91 wrote:Has anyone seen or built themselves a set of drawers that are a half-height setup?
Reason is, i've now got an ML tray with hard tonneau and am looking to maximise the space in there without getting a canopy. I want a half-height drawer on one side only so i can house all my recovery gear in that. I'll put the second battery and compressor behind the wheel arch on that side to fill in the space.
Any info would be great. Cheers
trumpy955 wrote:Love it !!!
I'd love similar but just one long drawer next to fridge but still the boxes behind wheel arches.
DDwr450f wrote:Thanks Trouble, the last set i did was like that, basically
the same as above but a draw that slid out the same length
as the fridge slide.
Users browsing this forum: No registered users and 56 guests