Ok so some Challenger specific pics for the Scott's Rods 3" system
Installed this morning as mentioned in the
Group Buy thread. Took just over 2 hours, no real dramas.
Unwrapped product from
Scott's RodsStarted at the dump pipe by removing the splash covers then the 3 bolts holding the dump pipe on. The top and engine side are actually lock nuts on studs, as you can see my studs came out with the nuts.
With the old exhaust out I lay them side by side for comparison. Also changed over the rubber hangers while they were there so that I got them all in the right spot.
When installing the new dump pipe and cat, this is the most important bolt. The top 3 were installed loosely (3mm gap) whilst this one was jiggled into place and tightened. When the top 3 were tightened first I couldn't get this one even close to the mount.
End results:
Big thank you to
Tony,
Fez and
Scott's Rods for organising the Group Buy.