Hi guys
There are some great set-ups there that's for sure. I'm just about to start on mine so I've a few theories and questions to my method of madness
Ok this is my plan so I'd appreciate any feedback (my model is an MN)
* I'm going to relocate the hazard switch to beside the blank switch on the right side of the dash near the mirror switch OR on the opposite side of the dash just underneath the wiper stick
* I will mount the two-way radio speaker mic clip over the hole from the hazard light switch, my two-way has everything on the handpiece.
* Going to relocate the rear power window switch which is in a stupid place to a more friendly place just to the left of the handbrake when it's down there is a square space in the console
* Where the little like ashtray pocket is in front of the transmission, I'm thinking to mount a 5-7 gang plate for the Carling type rocker switches, but I will mount it on an slight forward angle to the lid of this pocket, cover the ends properly and spray the entire gang plate the same silver as the dash around that part
* If need be, relocate the SRS AIRBAG circle warning light on the left of the dash near the air/con controls to down lower near the power socket where the rear window switch currently is. That will allow me to put another clip for a two-way radio should I need to run two.
Would anyone happen to know if I disconnect this above mentioned warning light will that set the airbag light off on the dash requiring a trip to Mitsubishi?
I've got my Boggard Turbo timer currently on the black part of the dash, just behind the indicator stick.
I had Custom Rockers make me some custom LED switches for my work truck and these work really well. From memory they were $20 each