L200Shogun wrote:http://www.ebay.com.au/itm/MITSUBISHI-TRITON-4X4-ML-MN-06-15-FRONT-UPPER-SHORTEN-BUMP-STOP-/131772179240
MN are 540mm from the factory (centre rim to bottom of flare) 575mm is about the limit you can lift them and still have good suspension travel so really a 1" lift (ML where 520 so 575 would be a 2" lift)
More than likely you have "lifted" a little too far. CV angles become a problem.
ag9111 wrote:You would either have to change the coils or add more weight, like a winch.
Front struts have no effect on height. They only limit the coils rebound
Sounds like your coils are incorrect, assuming the install was done correctly.
4wd26 wrote:check out if they have preinstalled the collar which is the coil seat on the upper or lower setting.
the Blistien struts allow for 2 positions, and the "helper spring" bit to combat the bulbar suggests that they might have set it at the higher position.
If this is the case you will be able to reuse everything you already have, just need to relocate the bottom coil holder to the lower position, not something you can do at home, but cheaper than new stuff.
Users browsing this forum: No registered users and 17 guests