by Intruder on Fri Aug 02, 2019 1:38 pm
FYI, copy and paste below from workshop manual (which you can download following links in the directory tab at top of page) for this code. I have not pasted the full diagnostic procedure though.
When you say replaced the SCV with "the original" do you mean you put back in the original SCV that you replaced or you replaced your e-bay purchased one with with a new Mitsubishi supplied one?
Assuming the SCV you have in the car is all good, according to the workshop manual for this code, first diagnosis is to check condition of your battery. If that is good, then Mitsi need to run through the diagnosis procedures listed in the workshop manual using a MUTT3 tool.
Good luck.
Code No. P0089: Suction Control Valve Stuck
OPERATION
•Battery power is supplied from the engine-ECU (terminal No. 131) to the suction control valve (terminal No. 1).
•The engine-ECU (terminal No. 146) turns on the power transistor to flow current to the suction control valve (terminal No. 2).
FUNCTION
•The engine-ECU monitors the signals input from the rail pressure sensor.
•The engine-ECU monitors the difference between the target fuel pressure and actual fuel pressure to check whether the suction control valve is open or fixed.
TROUBLE JUDGMENT
Check Conditions
•Battery positive voltage is 8 − 16 V
•2 seconds later after the ignition switch has been in "ON" position or the engine has started up
Judgment Criterion
•The actual rail pressure remains higher than the objective rail pressure by 10 MPa or more for a certain interval.
PROBABLE CAUSES
•Failed suction control valve
•Failed engine-ECU
Yes... I'll have another beer.