Used canopy on a used triton.

Bull bars, sliders, wheel carriers etc!

Used canopy on a used triton.

Postby WhiteTritonMN on Tue Aug 18, 2020 4:14 pm

I just bought a second hand canopy (original Mitsubishi) for a triton MN and it isn't fitting properly. The front of the canopy is raised and won't lower leaving a gap closest to the cabin. The bolts closest to the end of the tub are attached but the front two aren't.

I'm thinking this black metal plate that's pop rivoted to the tub has something to do with it. What is this plate?

I'm thinking I will drill out the pop rivets and this plate will come free and the canopy will just fall into place. Any other suggestions or ideas on what's going on?

Is this metal plate for a hard lid or other tonneau setup? Click to view larger pictureClick to view larger picture

Sent from my CPH1979 using Tapatalk
WhiteTritonMN
 
Posts: 3
Joined: Tue Jun 16, 2020 6:26 pm


 

Re: Used canopy on a used triton.

Postby DaveXT on Wed Aug 19, 2020 2:10 pm

Looks like that bracket is from a past canopy that was removed. That Tub liner doesn't seem to come up high enough either.
DaveXT
 
Posts: 92
Joined: Sun Apr 04, 2010 6:20 pm

Re: Used canopy on a used triton.

Postby WhiteTritonMN on Sat Aug 22, 2020 6:31 pm

Will it cause an issue if the tub liner doesn't come up high enough?

Sent from my CPH1979 using Tapatalk
WhiteTritonMN
 
Posts: 3
Joined: Tue Jun 16, 2020 6:26 pm


Return to Exterior Mods

Who is online

Users browsing this forum: No registered users and 0 guests