sandwich plates

Anything Triton related

sandwich plates

Postby ozitriton09 on Thu Oct 31, 2019 12:06 pm

Hi all , anyone used a sandwich plate on there 2.5 to connect oil pressure gauge to and any issues , reading up its advised not to use the brass t piece off the oil sender as they tend to break due to vibration , any thoughts?
ozitriton09
 
Posts: 9
Joined: Tue Sep 03, 2019 11:23 am


 

Re: sandwich plates

Postby RHKTriton on Fri Nov 01, 2019 6:43 am

I've considered the sandwich plates but put off by the possible extra spot for oil leaks.

With the brass fitting, you'd put the lightest sensor on the spot which is further away from the block.

If you were really concerned about vibration, you could possibly brace it.
Don't let the b'strds get you down!!
RHKTriton
Platinum Subscriber
 
Posts: 4380
Joined: Wed Jun 10, 2009 10:05 pm
Location: La trobe Valley - Gippsland

Re: sandwich plates

Postby RHKTriton on Fri Nov 01, 2019 6:43 am

I've considered the sandwich plates but put off by the possible extra spot for oil leaks.

With the brass fitting, you'd put the lightest sensor on the spot which is further away from the block.

If you were really concerned about vibration, you could possibly brace it.
Don't let the b'strds get you down!!
RHKTriton
Platinum Subscriber
 
Posts: 4380
Joined: Wed Jun 10, 2009 10:05 pm
Location: La trobe Valley - Gippsland


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 2 guests